Plumbing · Bend, Oregon
Plumbing inspection readiness
for Bend.
Send us photos of your plumbing work and your tracking list. Get a written findings report within 24 hours* — before your inspector does.
DWV, water supply, gas piping, water heaters, fixtures, and IPC/UPC compliance.
$250, one time · Nothing new, no charge · You keep the report either way
*Depending on availability. We'll confirm turnaround when you submit.
Code Buddy's Inspection Readiness Report checks your plumbing work in Bend, Oregon against the codes and specs that apply. Send photos of dwv, water supply, gas piping, water heaters, fixtures, and ipc/upc compliance and your tracking list — get a written findings report within 24 hours* scoring every item. $250, one time — nothing new found, no charge.
Trusted by teams at
Common questions
What teams ask about plumbing inspections in Bend
These are the questions field teams ask before an inspection. Our report answers all of them for your specific job.
plumbing inspection preparation in Bend?
what do plumbing inspectors check in Bend?
plumbing rough-in inspection checklist in Bend?
water heater inspection requirements in Bend?
DWV inspection prep in Bend?
Three steps. Five minutes.
Submit your plumbing job, and our patent-pending AI reviews every photo against the standards that apply in Bend.
Tell us about your plumbing job.
Project name, address in Bend, and scope. We look up the applicable standards automatically.
Send photos of your plumbing work.
Upload directly, share a Drive/Dropbox link, or email them. Your existing tracking sets the bar.
AI reviews every photo.
Cross-references against codes, specs, and your tracking — flagging plumbing deviations your list missed.
Get your report within 24 hours*.
Each finding includes the photo, location, and reference. Sorted by severity.
Plumbing findings we help catch in Bend.
Examples based on past reports — each includes the photo, location, and the reference checked against.
Roof truss design lacks required 40 psf ground snow load capacity per Bend's high-desert elevation classification
Exterior siding in wildfire-urban interface zone does not meet Class A ignition-resistant material requirements
Heating system duct insulation below R-8 minimum required for Bend's climate zone 5 dry designation
Hold-down anchor bolt spacing exceeds maximum for seismic design category D lateral force resistance
Solar panel conduit penetrations through roof lack required fire-rated sealant at wildfire interface parcels
Exterior hose bibb missing required freeze-proof stem length for cold-dry climate winter conditions
And only if we identify something that wasn't already on your list.
If everything identified was already on your list, you pay nothing. You keep the report either way.
GET YOUR PLUMBING REPORTLimited spots each week.
Every report is reviewed by a QA professional before delivery. Submissions are reviewed in order received.