Plumbing · Bloomington, Minnesota
Plumbing inspection readiness
for Bloomington.
Send us photos of your plumbing work and your tracking list. Get a written findings report within 24 hours* — before your inspector does.
DWV, water supply, gas piping, water heaters, fixtures, and IPC/UPC compliance.
$250, one time · Nothing new, no charge · You keep the report either way
*Depending on availability. We'll confirm turnaround when you submit.
Code Buddy's Inspection Readiness Report checks your plumbing work in Bloomington, Minnesota against the codes and specs that apply. Send photos of dwv, water supply, gas piping, water heaters, fixtures, and ipc/upc compliance and your tracking list — get a written findings report within 24 hours* scoring every item. $250, one time — nothing new found, no charge.
Trusted by teams at
Common questions
What teams ask about plumbing inspections in Bloomington
These are the questions field teams ask before an inspection. Our report answers all of them for your specific job.
plumbing inspection preparation in Bloomington?
what do plumbing inspectors check in Bloomington?
plumbing rough-in inspection checklist in Bloomington?
water heater inspection requirements in Bloomington?
DWV inspection prep in Bloomington?
Three steps. Five minutes.
Submit your plumbing job, and our patent-pending AI reviews every photo against the standards that apply in Bloomington.
Tell us about your plumbing job.
Project name, address in Bloomington, and scope. We look up the applicable standards automatically.
Send photos of your plumbing work.
Upload directly, share a Drive/Dropbox link, or email them. Your existing tracking sets the bar.
AI reviews every photo.
Cross-references against codes, specs, and your tracking — flagging plumbing deviations your list missed.
Get your report within 24 hours*.
Each finding includes the photo, location, and reference. Sorted by severity.
Plumbing findings we help catch in Bloomington.
Examples based on past reports — each includes the photo, location, and the reference checked against.
Footing depth measured at 38 inches, does not meet Bloomington's 42-inch minimum frost depth requirement
Rooftop unit condensate drain line not heat-traced or insulated for Minnesota freeze protection
Tamper-resistant receptacles not installed in dwelling unit as required by Minnesota Electrical Code
Continuous insulation not maintained at cantilevered floor over unheated space per energy code
Water supply piping in exterior wall cavity not insulated against freezing per Minnesota amendment
Exit sign illumination below minimum one foot-candle at floor level in commercial corridor
And only if we identify something that wasn't already on your list.
If everything identified was already on your list, you pay nothing. You keep the report either way.
GET YOUR PLUMBING REPORTLimited spots each week.
Every report is reviewed by a QA professional before delivery. Submissions are reviewed in order received.